Posted on Leave a comment

How to make your own climbing holds

Step by step guide to creating your own wooden, plastic free climbing holds for a home training board.


Home climbing walls are becoming a pretty big deal, what with ‘ahem’ not being able to roam free at the moment. Home training is a cost effective way to stay strong, and to maximise training time; being able to do it in bursts in between dinner, putting kids to bed, washing pots blah blah blah.

As per usual, we gathered together random bits of wood to make our holds out of. We already had everything in the house so didn’t need to buy in anything. Woohoo – free holds!


1. Get wood.

This is a branch kept from a condemned Hawthorn tree. It is a nice dense hardwood, good to work with. Nice and chunky. You can use any old branch/wood scrap provided it is dead and dry with some weight. Using a rasp, I shaved off the bark into a rough shape and size on one edge.

2. Saw bits off.

Carefully saw off end at desired length. Be careful to get a square cut as this side of the hold will be against the wall.

3. Drill and countersink.

Drill two holes 4/5mm approximately two inches apart (distance will depend on the size of wood you are using). Then counter sink both holes to accommodate the screw head. Counter sinking creates a tapered hole about 5mm in depth. This can be done either using a tapered counter sinking bit or with a 10mm drill bit, drilling 5mm into each hole.

4. Flip and mount.

Now, flip the hold over – flat side up. I temporarily screwed it to something solid (wood cutting horse, for example) to keep it secure for the next step.

5. Shave more.

I then shaved the opposite edge on the opposite side to create a tapered hold. We are going for a small jug, here. But you can do anything you want, be creative.

6. Rough sand and shape.

I have a fancy machine but this can be done with a coarse sand paper block and some elbow grease or an electric hand sander. The aim is to smooth out the surfaces from the coarse rasp shaping, and to fine tune the shaping. No nasty splinters.

7. Fine sand.

250 or 400 grit paper works well. Sand away until nice and smooth.

8. Screw to board.

Voila. Get training. You can get creative and make lots of different shapes and sizes. Be sure to send us pictures of your finished pieces – we want to show them off too!

Advertisements
Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.